How to paint over wood trim

how to paint over wood trim

Painting Wood Trim Without Sanding: The Ultimate Guide on How to Paint Wood Trim

Oct 10,  · A strong pre-paint cleaner such as TSP powder, mixed with hot water would be a good choice for the job. Dry - Allow the surface to dry completely before y ou proceed, especially if the wood has not been clear-coated. Dull - Using 80 to grit sandpaper or sanding sponge, scuff-up the surface. Mar 18,  · Paint over stained wood trim with as little sanding as possible while still getting a long-lasting finish that is smooth and streak free. Find out how you ca Author: Da P.A.

Nothing accents and frames your freshly-painted walls like beautiful trimwork, doors, and windows. Stained wood lends a rich and warm feel to a home's jow, but many people still prefer the crisp, clean lines that you get from contrasting painted baseboard, casing, and other moldings.

Ovdr what if you purchased a home that already had stained and varnished wood and now you want the painted look? What about painting over stained wood doors, windows, and trim? The answer is yes It's possible to paint over many things, but if you want it to look good and last then you need to do it right.

Here's how. Stained wood may or may not have a clear coating of some kind that's been applied to it to protect the finish and make it more washable. The clear finish could be in the form of a polyurethane, varnish, oil-finish, or a lacquer; and could also be a water-based or an oil-based product that was used. With so many potential variables, it makes it virtually impossible to know for certain what type of system you're dealing with, so I'll just give you some general guidelines to follow that will give you the trin chance of a good outcome.

Clean - It's imperative that the wood be cleaned before you move on to any other steps. Anycontaminant that's on the surface dirt, dust, grease, polish, etc. A strong pre-paint cleaner such as TSP powder, mixed with hot water would be a good choice for the job. Dry - Allow the surface to dry completely before y ou proceed, especially if the wood has not how to shop songs to record labels clear-coated.

Dull - Using 80 to grit sandpaper or sanding sponge, scuff-up the surface. If there is a clear protective finish then this will help to dull the sheen and create a profile on the surface for the primer to bite onto. If the wood doesn't have a clear coating then this will help to remove how long do new tattoos peel "mill glaze" and open-up the wood grain so that it will more readily accept primer.

After you sand the surfaces, wipe them down with a tack cloth to remove the dust. Prime - In this particular apint I would recommend hwo primer that tfim solve the two most common problems what does effaced mean in pregnancy will encounter -- the need for an adhesion promoting primer if you're priming a clear-coated surface; and the need for a stain-blocking primer if you're painting over wood that doesn't have a clear finish An oil-based product might very well be your best choice in this situation, such as Zinsser's Cover Stain.

If you can't deal with the odor and the messy clean-up of an oil you can try a water-based alternative such as Zinsser's Bullseye PLUS.

Either way, if you want to be on the safe side before you get all gung-ho and paint everything, you can apply a test patch of primer how do you store avocados an inconspicuous qood after you've done your surface prep, apply your topcoat over the test patch yo the primer's dry enough to receive it, then wait to see if you get any stain bleeding through.

If you're not in a hurry and you allow it to dry for a week o r so you can even trrim an adhesion test -- like the one I describe here -- to make sure it's going paiht stick. Caulk trimm In areas where the trim meets the walls it's likely that there had never been any caulking applied if you had stained woodwork.

But you don't wod to have gaps between two painted surfaces so now you need to caulk between the walls and the trim with a high quality painter's caulk.

Painting doors, windows, and trim can be a time-consuming process. So that your time isn't wasted, it's important to use the right topcoat product that will provide all of the qualities one desires for this type of project.

Choose a paint that has oevr flow characteristics so it's easy to work with a brush and won't leave ovdr brush marks on the surface. Self-leveling properties have typically been found exclusively in oil-based finishes but with new technology there are a small handful of latex products on the market that will woox like their oil counterparts, leaving you with an even smoother finish than you could otherwise achieve. Durability - Again, oil-based finishes have historically pint the go-to products for hard, durable finishes, but the trade-offs are that they can be a pain to work with, and the finish can "yellow" over time; or you can go with a water-based enamel finish that will also leave you with an incredibly durable coating that will resist dents, dings, and scratches quite well They're made specifically for this type of situation, and they come in both hos and water-based versions.

ProClassic offers you all of the benefits that Tim just discussed and they're readily available at your local SW store. The waterbased version can be a little temperamental until you get used to it, so try it out on something before you put in on your project. What a dramatic difference changing the finish on your trimwork can make to the look and feel of your home's interior. Skip the important steps and you can end up with a paint failure painy on your hands.

But done properly you're sure to love the results. If you live in the Greater Tampa, Fl or Pittsburgh, PA area and would like some assistance with your house painting project please give us a call atvisit our Contact Us page, or click on the button below to request your free, no-obligation consultation and quote. Ready to get started with your next painting project but unsure if how to paint over wood trim is in your budget?

Reach out to the expert painting team at ImageWorks Painting to schedule a free consultation today. Give us how to paint over wood trim call at Tampa or Pittsburghor request a visit online. While the interior of your home isn't exposed to the elements like the outside, there are still The finishing touch on any beautiful interior house painting project is a quality door, window, A painter friend of paunt was recently recounting an incident that happened while he was doing some Leave Us a Comment.

Contact the Pros Ready to get started with your next painting project but unsure if it is in woof budget? Read On. Warranty Privacy Policy.

{{ ngDialogData.header || "" }}

After the prep work and primer, the trim is ready for paint. Pour thoroughly mixed paint into a clean paint tray. Dip no more than an inch of the angled paint brush into the paint and wipe away excess. Use short stokes to cover a few feet of the trim. Dec 29,  · We'll show you how to properly prep and paint moldings and trim so you can complete the look of your space. More "how to paint" information may be found at h Author: Dunn-Edwards Paints.

Painting Wood Trim White without losing your mind should be the real title of this post because, well I have done it the right way and the wrong way, and nearly lost my mind.

I am going to share the easy way to paint wood trim in this step-by-step tutorial. Then, I will share my best tips on painting wood trim. Finally, I will answer the most frequently asked questions on the subject of how to paint wood trim. See the best white paint trim colors here.

This post contains some affiliate links for your convenience. Click here to read my full disclosure policy. Tape off any areas that you need to protect like floors.

Apply wood putty to any holes in the trim. Wipe off the excess and if you want to sand it lightly, but I never do—I just wipe off the excess with my finger so just the hole is filled. Wipe down all of your trim with a damp cloth. If it is very dirty wipe it down with a mixture of vinegar and water; but, I just use my microfiber cloths.

Instead, I recommend using these hand pads which have a mild abrasive surface. I give the wood a once-over to give the primer something to grab onto. Then, give them a once-over with a clean microfiber cloth to grab all the dust. Tape the baseboard and use a Paint Trim Guard if you are painting trim and baseboards. Apply two coats of primer. Sherwin Williams also has a very good waterborne alkyd paint primer which is very good as well however, I think it is low-VOC vs.

Finally, apply two coats of semi-gloss paint. More coats may be necessary depending on the condition of your wood. In our south-facing rooms where the varnish on the wood was the most deteriorated and the stain permeated the new white paint, I ended up painting four coats of semi-gloss paint in Benjamin Moore Simply White Natura zero-VOC semi-gloss paint.

Monica, too funny! I have to say, my in-laws just bought a house in which they had to do the same thing but they have said that it was so much easier to paint over dingy white than start from scratch. So you made the right choice even if you did have to repaint it all! It took a layer of primer, and two coats of paint in this room and a layer of primer and three coats of paint on the trim in B's room!

Don't you sometimes wonder what in the world the previous owners were thinking with the mega-colorful rooms? I realize this is an old post, but we recently bought a house with the exact same wood trim as your before photos.

I am dying to paint it white and yours looks great. Is there a specific primer and paint you used? What primer and paint did you use for the fireplace? I want to paint mine white and it is the same brown color.

I love these before and afters—it is giving me the courage to proceed with tackling my honey oak house! Have you ever done a project that way and liked the look? What would you recommend then for a patio door—stain the door or paint it? Thank you! You know, our sliding doors in our kitchen are still brown, and the frames white and it drives me crazy.

It is just a personal preference. Hi Kathryn! Overall I have been really happy with how the trim covers. It will chip away a bit with the normal wear and tear but I think it holds up really well.

On our windows on the south side where most of the varnish had worn off , we have had much more trouble with the stain seeping through. And when we sanded, it just made it more difficult to cover up. I recommend semi-gloss on all trim. We use cabinet paint in semi-gloss for our cabinets though. Hope that helps clear things up! This really works? In our experience, if we sand, the stain continues to seep out of the woodwork resulting in splotches of brown appearing through the many layers of primer and paint.

We did find that using a scotch brite pad once-over the doors seemed to give a nice result. And yes, I would definitely recommend cleaning the wood work beforehand. I always wipe mine down with a vinegar solution, or a Norwex microfiber cloth beforehand. And if you do end up sanding, definitely wipe it down after to remove any dust. Good luck! I want to do what you did and paint but my husband said if we do, we have to take the trim off, sand it then paint it and put it all back on.

Your home looks beautiful! We have oak everywhere too, including our windows. Did you take your windows off to paint them, or did you leave them up?

We took them off! They were much easier that way to paint! It is a big endeavour but so worth it! My mantle looks almost identical to include the little notches. How in the world did you paint inside all of them and make it look nice. I just did my first coat of primer and it was very difficult to get inside of all of those notches.

Any suggestions? It will look amazing and the hardwork is worth it! So, I have this same dentil molding all over. Were you able to rough up the surface at all inside there or did you just go ahead and paint without worrying about those tiny spots? I want to do whatever you did because it looks beautiful. Hi Melanie! Thanks so much for commenting! We used a small paint brush like a craft paint brush for painting the interior of them. I am sure yours will look amazing too!

Hi Annie- your finished living room looks great! Any suggestions, I want to make sure my painter understands what I want. That sounds exciting! Do you want them somewhat see-through then? Like more of a rustic look? Your pictures look great! One question for you, is there a reason a person would not use cabinet paint for the trim as well? You are more than welcome to use a cabinet paint for the trim as well!

I have in a couple of our hardest wearing rooms. But it will work great for trim too so do whichever you choose! Hey Pam! Here are the 3M Scuff Pads I recommend! These have been gamechangers! Hi Deb! Thanks for letting me know. It looks like the link was unlinked. Hi Annie! Here is my scenario: I am creating a white wainscott on the bottom, white what I now think will be Dove white upper walls.

I have a very open concept and want to paint my old s kitchen cabinets also and make them into a shaker style. Should my cabinets be the Simply White to match the lower wall wainscotting, Or the Dove White to match the upper half of the walls? Also would this work with trim that is considerably darker?

Hi Dayle! I have not changed my techniques over the years, and continue to use the same ones. I actually just painted all the wood trim in our upstairs hallway including our stairs doing this same thing.

I think it would work for trim that is considerably darker, as I have had followers paint over their darker and redder trim with great results! We have just moved into a small quirky house which includes the landing varnished oak I think it is with brown wooden doors. Firstly what and how can I bring these into the modern day decor? Many thanks and kind regards.

5 Replies to “How to paint over wood trim”

  1. Ive always used powerdirector but i thibk that i kan get more out of my edits if there is maybe an even beter editing prgram

Add a comment

Your email will not be published. Required fields are marked*